NetApp 7-Mode: Replace Failed Hard Drive (Illustrated)

1. Log in to the controller

1. Check vol status -f to confirm only one drive is failed

1. storage show disk -p View the drive's location (this physical location corresponds to cabinet #1, slot #22, 0b.01.22)

1. Go to the identified location to check for a hard drive with an amber light and perform the physical replacement.
2. Then check disk show -v

1. Run disk assign 0b.01.22 to assign the newly installed drive to the controller. Then run disk show -v again to verify.

1. After running vol status -s, the amber light should turn off. The hard drive replacement is complete.

Images localized into English for illustration; labels may vary by product version.